Utility Solutions Jack Jumper USJJ-001 Quick Start Manual

Product Description

The Jack Jumper™ Cutout Bypass Tool permits a safe and quick method to bypass an overhead cutout without the tedious use of bulky jumper
cables. The tool is indispensable for fuse coordination tasks and permits easy bypass of an underground dip. The Jack Jumper™ Cutout Bypass
Tool saves time and money, eliminates risk of service interruption and prevents accidental cross phasing.
The primary purpose of the Jack Jumper™ Cutout Bypass Tool is to temporarily bypass a cutout fuse door during fuse coordination. The Jack
Jumper™ Cutout Bypass Tool is rated at 100 Amps continuous AC current without exceeding a 40°C temperature rise.
Installation and removal of the Jack Jumper™ Cutout Bypass Tool is done with a shotgun stick.
DANGER
!
Contact with high voltage will cause death or grievous personal
injury to the operator. Only use this device in conjunction with
safe operating practices around energized lines and equipment.
WARNING
!
Carefully read and fully understand the INSTRUCTION
MANUAL prior to operating, maintaining or testing this
device. Improper operation, handling or maintenance of this
device can result in death, grievous personal injury and or
equipment damage.
WARNING
!
Follow safe work procedures and practices when utilizing this
device. Failure to use this device in a safe manner can result in
death, grievous personal injury and or equipment damage.
WARNING
!
These instructions are not intended to replace or be a substitute
for proper safety training procedures. Failure to select the proper
tool in regards to minimum system requirements can result in
death, grievous personal injury and or equipment damage.
WARNING
!
Never install or remove a Jack Jumper™ Cutout Bypass Tool on
an open cutout.
Phone (828)323-8914
Fax (828)323-8410
sales@utilitysolutionsinc.com
Email
Web www.utilitysolutionsinc.com
101 33 Street Drive SE · Hickory, NC 28602
rd
Jack Jumper™ Cutout Bypass Tool
!
!
!
!
!
© 2018 Utility Solutions Inc.
C-00804 USJJ-001/2 Instruction Manual (9-7-18)
Perpendicular Ring
Spring Mechanism
!
Only trained and qualified personnel should operate, inspect
and maintain this device.
USJJ-001 15 kV Cutout Bypass Tool
USJJ-002 27 kV Cutout Bypass Tool
WARNING
Attachment Hooks
In-Line Ring
!