Advertisement
Install the Floor Mats
Install the mats during the TQI, and be sure to place
the eyelets in the driver's mat over the anchor hooks on
the floor. Also place the eyelets in the second-row floor
mat over the anchor hooks on the floor under the front
seats.
NOTE: Models with the Entertainment Package include
a third-row floor mat.
ANCHOR HOOKS
ANCHOR HOOKS
Check/Set the Tire Pressures (Including the Spare
Tire)
To prevent flat spots during shipping and storage, the
tires are inflated to 40–50 psi. To avoid client
complaints about harsh ride quality, adjust the cold tire
pressures to these readings:
• Tires – 32 psi (front and rear)
• Spare – 60 psi
NOTE: If you are in a colder climate, make sure the
tires are at the outside ambient temperature before
setting the pressure.
07-044
Install the Front License Plate Holder
The front license plate holder and mounting hardware
are in the rear cargo area. If state regulations require
that a front license plate be installed, do this:
1. Reach behind the front bumper, and remove the
two bumper plugs by releasing the lock tabs.
2. Insert the two clip-nuts, install the holder onto the
bumper with the two washer-bolts, and then install
the license plate.
NOTE: The remaining hardware in the kit is for
attaching the rear license plate to the rear license plate
holder.
WASHER BOLTS
Install the Front Strakes
The front strakes are removed before shipping to
prevent them from being damaged. The strakes are
packaged with the license plate holder. Using the six
clip-nuts and screws provided in the TQI kit, install the
front strakes to the front inner fenders.
CLIP-NUTS
CLIP-NUTS
FRONT INNER
FENDER
FRONT
STRAKE
SCREWS
3 of 7
Advertisement
