Safety Instructions - Omnitronic XMT-1400 MK2 User Manual

2 Safety Instructions

Caution!
Keep this device away from rain and moisture!
Caution!
Be careful with your operations. With a
dangerous voltage you can suffer a dangerous
electric shock when touching the wires!
Caution!
his device is equipped with a class 1 laser
T
diode. To ensure safe operation do not remove
any covers or attempt to access the inside of
the product.
This device has left our premises in absolutely
perfect condition. In order to maintain this
condition and to ensure a safe operation, it is
absolutely necessary for the user to follow the
safety instructions and warning notes written in
this user manual. Damages caused by the
disregard of this user manual are not subject to
warranty. The dealer will not accept liability for
any resulting defects or problems.
Unpacking
• Please make sure that there are no obvious
transport damages. Should you notice any
damages, do not take the device into operation
and immediately consult your local dealer.
• Save the package and all packing materials. In
the event that a fixture must be returned to the
factory, it is important that the fixture be
returned in the original factory box and packing.
Protection Class
• This device falls under protection class II and
features a protective insulation. The power plug
must only be plugged into a suitable outlet. The
voltage and frequency must exactly be the same
as stated on the device. Wrong voltages or
power outlets can lead to the destruction of the
device and to mortal electrical shock.
Power Cord
• Always plug in the power plug least. The power
plug must always be inserted without force.
Make sure that the plug is tightly connected with
the outlet.
• Never let the power cord come into contact with
other cables! Handle the power cord and all
connections with the mains with particular
caution! Never touch them with wet hands, as
this could lead to mortal electrical shock.
• Never modify, bend, strain mechanically, put
pressure on, pull or heat up the power cord.
Never operate next to sources of heat or cold.
Disregard can lead to power cord damages, fire
or mortal electrical shock.
• The cable insert or the female part in the device
must never be strained. There must always be
sufficient cable to the device. Otherwise, the
cable may be damaged which may lead to
mortal damage.
• Make sure that the power cord is never crimped
or damaged by sharp edges. Check the device
and the power cord from time to time.
• If extension cords are used, make sure that the
core diameter is sufficient for the required power
consumption
concerning the power cords are also valid for
possible extension cords.
• Always disconnect from the mains, when the
device is not in use or before cleaning it. Only
handle the power cord by the plug. Never pull
out the plug by tugging the power cord.
Otherwise, the cable or plug can be damaged
leading to mortal electrical shock. If the power
plug or the power switch is not accessible, the
device must be disconnected via the mains.
• If the power plug or the device is dusty, the
device must be taken out of operation,
disconnected and then be cleaned with a dry
cloth. Dust can reduce the insulation which may
lead to mortal electrical shock. More severe dirt
in and at the device should only be removed by
a specialist.
Liquids
• There must never enter any liquid into power
outlets, extension cords or any holes in the
housing of the device. If you suppose that also a
minimal amount of liquid may have entered the
device, it must immediately be disconnected.
This is also valid, if the device was exposed to
high humidity. Also if the device is still running,
the device must be checked by a specialist if the
liquid has reduced any insulation. Reduced
insulation can cause mortal electrical shock.
Foreign Objects
• There must never be any objects entering into
the device. This is especially valid for metal
parts. If any metal parts like staples or coarse
metal chips enter into the device, the device
must be
disconnected immediately. Malfunction or short-
circuits caused by metal parts may cause mortal
injuries.
16 • EN
of the device. All
taken out of operation
warnings
and