ASROCK Z790 Series Setup Manual page 52

ODT CK (B1 Group B)
Configure the memory on die termination resistors' CK.
Configuration options: [Auto] [40] [60] [80] [120] [240] [480] [Disabled]
ODT CK (B2 Group B)
Configure the memory on die termination resistors' CK.
Configuration options: [Auto] [40] [60] [80] [120] [240] [480] [Disabled]
Advanced Setting
ASRock Timing Optimization
Enable/Disable ASRock Timing Optimization. When enabled, the memory timing will use
ASRock optimized value.
Configuration options: [Enabled] [Disabled]
ASRock DRAM Frequency Optimization
Enable/Disable ASRock DRAM Frequency Optimization. When enabled, the DRAM
Frequency will run ASRock optimized procedure.
Configuration options: [Auto] [Enabled] [Disabled]
MRC Training Respond Time
Configure the MRC Training Respond Time.
Configuration options: [Auto] [Slowest]
Realtime Memory Timing
Enable/Disable realtime memory timings. When enabled, the system will allow performing
realtime memory changes after MRC_DONE.
Configuration options: [Enabled] [Disabled]
Reset for MRC Failed
Reset system after MRC training is failed.
Configuration options: [Enabled] [Disabled]
MRC Training on Warm Boot
When enabled, memory training will be executed when warm boot.
Configuration options: [Auto] [Enabled] [Disabled]
48