Step 8 - Wire Connections; Step 9 - Attach The Towing Coupler; Step 10 - Attach The Auger Coupler - Champion 90034 Owner's Manual And Operating Instructions

Assembly
Step 8 – Wire connections
The emergency stop wire contains a
white wire and black wire.
1. Remove gas tank nut (E) and attach
white wire to stud, replace nut.
2. Locate available snap in plug in the wire
bundle (B), and snap in to receptacle
plug (C) on the emergency stop wire
(black wire).
Step 9 – Attach the towing
coupler
1. Fasten the 2" ball coupler to the frame
using (2) M12x80 bolts, (2) Ø12 Flat
Washer and (2) M12 lock nut. Tighten.
2. Attach the towing chains to the towing
chain mount plate with (2) M12x45
bolts, (2) Ø12 Flat washers and (2) M12
lock nut. Bolt the first link in each
towing chain.
3. Tighten all hardware
8
Step 10 – Attach the Auger
coupler
1. Slide Auger coupler (C) into motor shaft
(E) and lock in place with a lock pin (D)
2. Place Ø10x32 cotter less hitch pin in its
storage location. This is the travel pin
and will be used for moving and towing
the Auger.
Rev 90034-20090416