Advertisement
Quick Links
OPTICAL DATA CONNECTOR
LASER POWER CONNECTOR
How to connect the RadiSense® 10
Connect the 'LASER POWER CONNECTOR' (FC/PC) of the probe
to the 'LASER APERTURE' of the plug-in card.
Connect the 'OPTICAL DATA CONNECTOR' (ST/PC) to 'OPTICAL
DATA LINK' connector of the Plug-in card.
Make sure the interlock of the RadiCentre® is connected correctly.
Insert the supplied interlock plug into RadiCentre®, and where
required, connect a safety interlock switch (for example a door
switch) in series with the interlock wire.
Advertisement
Related Manuals for raditeq RadiSense Essential Series
Summary of Contents for raditeq RadiSense Essential Series
- Page 1 OPTICAL DATA CONNECTOR LASER POWER CONNECTOR How to connect the RadiSense® 10 Connect the ‘LASER POWER CONNECTOR’ (FC/PC) of the probe to the ‘LASER APERTURE’ of the plug-in card. Connect the ‘OPTICAL DATA CONNECTOR’ (ST/PC) to ‘OPTICAL DATA LINK’ connector of the Plug-in card. Make sure the interlock of the RadiCentre®...
-
Page 2: Product Manuals
Product manuals Full product manuals of all raditeq products and EMC software are available on the Raditeq website. Download them now and read a detailed instruction on how to operate your raditeq products. https://www.raditeq.com/raditeq-downloads/downloads/ White Papers Raditeq has a leading role in product innovations for the EMC market. - Page 3 Quick Start Guide RadiSense® Essential Series Electric Field Probe Model: RSS2010E...
- Page 4 WARNINGS & PRECAUTIONS Read the contents of this product manual carefully and become familiar with the safety markings, the product instructions and the handling of the system. Please refer to the applicable product manual(s) for further information regarding the operation and control of the product(s). The RadiSense®...
- Page 5 RadiSense®10E Laser Activation Press the ‘Start’ button on the back panel and hold it. 2. Hold the button until five beeps sounds are heard; four short beeps followed by one long beep. 3. On the fifth ‘beep’ the laser link is activated and the red ‘laser ON’ LED (on the Plug-in card) lights up.
- Page 6 Mounting the RadiSense® The use of the mounting angle is optional. For isotropic measurements of an electrical field of which the polarization is unknown (for example in reverb 123.1 chamber / mode-stir chambers) the mounting angle is not needed. For measurements of electrical field with a known polarization, the mounting angle can be used to position one axis of the RadiSense®...