Related Manuals for raditeq RadiPower RPR2006C
Summary of Contents for raditeq RadiPower RPR2006C
- Page 1 Product Manual RadiPower ® RF Power Meters Models: RPR2006C | RPR2006P | RPR20018C | RPR2018P www.raditeq.com...
- Page 2 For your convenience, a Quick Start Guide has been added to this product. This Quick Start Guide contains the basic start-up steps and the safety warnings. Please keep the Quick Start Guide (and this regular manual) close at hand when you operate your new Raditeq product(s).
-
Page 3: Table Of Contents
RadiPower® 2000 Series Command Set RadiCentre® command set Prefix & Communication example: Stand-alone command set Specifications RPR2000 Series Warranty Conditions Page 3 of 24 This manual is subject to change without notice Page 3 of 24 Copyright © 2008 - 2021 Raditeq B.V. -
Page 4: Warnings & Precautions
This product contains no hazardous substances as described in the RoHS Directive (2015/863/EU). This product contains embedded software, which is field upgradeable from the RadiCentre® using the USB-A connection port on the backside panel of the RadiCentre®. For more information about updating your Raditeq plug-in card, please read the RadiCentre® manual. -
Page 5: Introduction
RadiCentre® plug-in cards and modules. RadiMation® Software RadiMation ® is the EMC software package from Raditeq used for remote control and automated testing of the RadiCentre® plug-in cards and modules and is sold separately. -
Page 6: The Radipower® 2000 Series - Overview
The installation of RadiMation® Free software and drivers. • Optional - The calibration certificate for the power meter (if a certification was requested). This manual is subject to change without notice Page 6 of 24 Copyright © 2008 - 2021 Raditeq B.V. -
Page 7: The Radipower® 2000 Series
As the first two parameters are generally prescribed by standards, the only one that can be optimized is the speed of the power meter. The unprecedented detector technology of Raditeq’s power meters makes extremely fast and accurate power measurements a reality, even at low power levels. -
Page 8: Different Models - 2000 Series
“power?” -command will return the highest value that was measured since the last “power?” -command. After each cycle of the command the previous peak value is cleared, This manual is subject to change without notice Page 8 of 24 Copyright © 2008 - 2021 Raditeq B.V. - Page 9 When this peak is detected the power meter will store the 2000 samples before and after the trigger occurred. This manual is subject to change without notice Page 9 of 24 Copyright © 2008 - 2021 Raditeq B.V.
-
Page 10: Installing The Radipower® Plug-In Card (Usb1004A Only)
Installing the RadiPower® plug-in card (USB1004A only) Please follow the instructions below on how to install the Raditeq plug-in card into the RadiCentre® correctly. NOTE: Before installing and inserting a new plug-in card make sure that the RadiCentre® is turned OFF. -
Page 11: Radicentre® & Usb1004A - Manual Control
RadiPower® power meters. To monitor the measured power level(s), one can go to the ‘control’ screen by pressing the RadiPower® ‘status’ button. RadiCentre® home screen RadiPower® Status Screen RadiPower® Caluclation This manual is subject to change without notice Page 11 of 24 Copyright © 2008 - 2021 Raditeq B.V. -
Page 12: Frequency Settings
The user can also enter the filter setting, to select a ‘filter time constant’. For more information on the available filter settings, please refer to the ‘RadiPower® Specifications’ section of this manual. This manual is subject to change without notice Page 12 of 24 Copyright © 2008 - 2021 Raditeq B.V. -
Page 13: Calculation Functions
The ‘VSWR’ function will calculate the VSWR based on the measured forward power and reflected power between two ports (in U). This manual is subject to change without notice Page 13 of 24 Copyright © 2008 - 2021 Raditeq B.V. -
Page 14: Radipower® Installation
Windows to install the drivers manually. Once the drivers are loaded successfully, the RadiPower® will be shown in the device list. This manual is subject to change without notice Page 14 of 24 Copyright © 2008 - 2021 Raditeq B.V. -
Page 15: Software Configuration
RPR2006C | RPR2006P | RPR20018C | RPR2018P | USB1004A Software Configuration In order to control the RadiPower® from a computer, the RadiMation® EMC software package can be used. RadiMation® from Raditeq is sold separately. A free version of RadiMation® is available on: https://www. raditeq.com/automated-emc-software/radimation-free/. -
Page 16: How To Connect The Radipower® To The Radicentre
Finally select the ‘Check’ button on the right side of the opened screen. When correctly configured, RadiMation® will notify you that the device is correctly installed. This manual is subject to change without notice Page 16 of 24 Copyright © 2008 - 2021 Raditeq B.V. - Page 17 If all necessary power meters are added in the configuration, the measurement can be setup and all RadiPower® can be connected to the USB ports of the PC. This manual is subject to change without notice Page 17 of 24 Copyright © 2008 - 2021 Raditeq B.V.
-
Page 18: Remote Control
RPR1004A RPR1004A RPR1004A RPR1004A Refer to the RadiCentre® manual, for more information on the command sets, error codes and device numbers. This manual is subject to change without notice Page 18 of 24 Copyright © 2008 - 2021 Raditeq B.V. -
Page 19: Prefix & Communication Example
PC the prefix is not required or necessary. Communication with the RadiPower® sensor is possible using a virtual COM-port (VCP) For more information see chapter ‘stand alone configuration’. This manual is subject to change without notice Page 19 of 24 Copyright © 2008 - 2021 Raditeq B.V. -
Page 20: Specifications Rpr2000 Series
0° to 40° Celsius Temperature range (storage) -20 to 85º C Relative humidity 10 – 90% (non-condensing) Warranty 3 years* (excluding misuse) This manual is subject to change without notice Page 20 of 24 Copyright © 2008 - 2021 Raditeq B.V. - Page 21 Typical specifications indicate that the measured values are met on at least 80% of the points. • Three years warranty will be granted only after you register your product at www.raditeq.com. Without • registration, a 1 year warranty period applies.
-
Page 22: Warranty Conditions
Warranty Conditions Raditeq B.V. offers a standard warranty term of three (3) years on their products, calculated from the shipping date, under the condition that the product is registered on www.raditeq.com. For registration of the product, the customer should provide the product model, serial number and the responsible reseller (if applicable). - Page 23 The technical construction files are maintained at the adress specified above. Date of issue: 09/06/21 Place of issue: Woerden, The Netherlands Authorized by: P.W.J. Dijkstra Title of authority: Director This manual is subject to change without notice Page 23 of 24 Copyright © 2008 - 2021 Raditeq B.V.
- Page 24 RadiPower® Product Manual RPR2006C | RPR2006P | RPR20018C | RPR2018P | USB1004A Raditeq B.V. | Vijzelmolenlaan 3 | 3447GX Woerden | The Netherlands Raditeq B.V. | Vijzelmolenlaan 3 | 3447GX Woerden | The Netherlands www.raditeq.com | T:+31 348 200 100 www.raditeq.com | T:+31 348 200 100...
Need help?
Do you have a question about the RadiPower RPR2006C and is the answer not in the manual?
Questions and answers