Table of Contents
Advertisement
DRO 100
Setup
Setup
The
key lets you change the system parameters. The keys you use to change
SETUP
setup parameters are different for one-axis and two-axis readouts. To move from
one parameter to the next, press the upper
key (the
key for a single-axis
ZERO
SETUP
readout). After the last parameter, the same key ends the setup process and saves
any changes.
Some parameters may be set differently for each axis. For these parameters, the
display will indicate the axis by number. For example, linear error compensation
factors are indicated by LEC1 for the first axis and LEC2 for the second axis.
Some parameters have choices. Use the lower
key to cycle through these
ZERO
choices. If you have a single-axis readout, use the only
key whenever the
ZERO
lower
key is referred to.
ZERO
Display Resolution
The display resolution will be the same as the encoder resolution. If the job
tolerance is coarser than the encoder resolution (±0.005, for example), you can
adjust the display resolution so you won't be tempted to waste time by machining
to a finer resolution. Use the lower
key to cycle through all the possible
ZERO
choices. The choices available depend upon the resolution of your encoders.
7
Advertisement
Table of Contents
