Table of Contents
Advertisement
Safety
The safety messages contained in this manual are bold and highlighted in red for quick
identification. A Danger message indicates an imminently hazardous situation which, if
not avoided, can result in death or serious injury. Messages identified by the word
DANGER are used sparingly and only for those situations presenting the most serious
hazards. The following is a typical example of a Danger message as it could appear in
the manual.
HIGH VOLTAGE - RISK OF SERIOUS INJURY OR DEATH
The equipment covered by this manual is designed for safe and reliable operation when
installed and operated within its designed specifications. To avoid personal injury or
damage to equipment or property when installing or operating this equipment, it is
essential that qualified, experienced personnel perform these functions, using good
judgment and safe practices. See the following cautionary statements. Installation and
maintenance of this equipment is to be performed only by qualified personnel who are
familiar with local codes and regulations and are experienced with this type of
equipment.
Exposure to safety hazards is limited to maintenance personnel working in and around
the unit. When performing maintenance, always use the Lockout/Tagout procedure,
which is described in this chapter. Observe the maintenance safety guidelines in the
Wine Guardian Manual.
Electrical Hazards - Working on the equipment may involve exposure to dangerously
high voltage. Make sure you are aware of the level of electrical hazard when working on
the system. Observe all electrical warning labels on the unit. There are no electrical
safety lockouts installed within the unit. The power cord attached to the control box must
be disconnected from the power sources prior to working on any part of the electrical
system.
Moving Parts Hazards - The motor and blower must be disconnected prior to opening
access panels. The motor can start automatically. Disconnect all power and control
circuits prior to servicing to avoid serious injuries or possible dismemberment. Be sure
to use the Lockout/Tagout procedure when working on these units.
High voltages are present in the cabinets.
Before opening panels turn off all power.
Use the Lockout/Tagout procedure.
4
Advertisement
Table of Contents
