Dashboard Indicators - Yellowtec iXm Briefing Book

Dashboard Indicators

1. Boot sequence
When you turn on your iXm, the REC LED will flash green during boot
sequence. Once the boot sequence is finished the MEM LED will flash red
to indicate a memory check of the SD card. With no memory card inserted
the MEM LED will continuously flash red to indicate that the iXm will not
be ready to record.
2. BAT and MEM capacity check
When the iXm is powered up and you are not recording, you can
always recall the remaining battery power and the remaining memory
capacity. To indicate the time remaining simply hit the STOP button on
the dashboard. First, the BAT LED will slow-flash yellow followed by a
yellow slow-flashing MEM LED. Each flash indicates the approximate
number of remaining hours of BAT or MEM capacity. Use this function
regularly to assure that your required recording time is safe.
3. REC ready and recording
You can select three different recording modes via software
configuration. Each mode will be displayed by the REC LED with a
different flash pattern.
Single flashes will indicate REC ready with no other options active:
Double flashes will indicate REC ready with pre-roll active:
34