Advertisement
8.
Install the Front Strakes
Install the front strakes as shown.
Vehicle Exterior (Vehicle Lowered to Half-Height)
9.
Install the Front License Plate Holder
If state regulations require the use of a front license plate, install the front license plate holder as shown.
Vehicle Exterior (Vehicle Lowered to Ground)
10.
Set the Tire Pressures, and Remove the TPMS Labels
To prevent flat spots during vehicle shipping and storage, the tires are inflated to over 40 psi. If the vehicle is going into
dealer storage, leave the tire pressures at 40 psi until it is sold (see the Perfect Delivery Action Plan).
If the vehicle is moved to the showroom/sales lot or is sold, set the tire pressures as follows:
NOTE:
•
You must do these steps exactly as written to ensure the TPMS Fill Assist System works right.
•
If you are in a cold climate region, make sure the tires are at the same temperature as the outside air before
adjusting the pressures; otherwise, the Low Tire Pressure/TPMS indicator may come on in cold weather.
Page 6 of 11
Advertisement
