Advertisement
The indicator will switch from blinking to steady when communication is complete.
3. Start the engine by pressing the ENGINE START/STOP button while applying the brake pedal. You must start
the engine within 10 seconds. If you press the button without applying the brake pedal, the ignition will go to
ACCESSORY.
1.
Install the Backup Fuse
To lower battery drain during vehicle shipping, the No. 29 BACKUP (10 A) fuse is removed from the main under-hood
fuse/relay box and stored in the tray inside the technology pocket, ahead of the SBW shifter (6-cylinder models) or shift
lever (4-cylinder models). Make sure the ignition is turned to OFF before installing this fuse.
2.
Fuel the Vehicle
Fill the fuel tank with 91 or higher octane unleaded gasoline. Make sure the No. 29 BACKUP (10 A) fuse is installed
before you do (see "Install the Backup Fuse"). If you do it without the fuse installed, the fuel gauge will take much longer
than normal to show an accurate reading.
If this happens and you do not want to wait for the gauge to show the correct level, turn the ignition to OFF and let the
vehicle sit for 10 minutes. Install the fuse, then turn the ignition to ON. The fuel gauge will show the correct level.
Page 3 of 11
Advertisement
