Advertisement
17.
Check the Compass Calibration (Trim Levels Without Navigation)
If the compass shows the wrong direction or the CAL indicator blinks, manually calibrate the system with this procedure:
NOTE: Do this procedure in an open area, away from buildings, power lines, and other vehicles.
1. Turn the ignition to ON.
2. From the top screen of any audio source, press and hold the ENTER button for 10 seconds. The display will
switch to the Compass Settings screen.
3. Turn the interface dial to select Calibration, then press the ENTER button.
4. When the display changes to Calibration, Start, press the ENTER button.
5. Drive the vehicle slowly in two complete circles. The compass should show a direction, and the CAL indicator
should go off.
18.
Check/Refresh the SiriusXM
The audio system comes from the factory activated with the SiriusXM
No. 29 BACKUP (10 A) fuse, the system should receive the full range of available channels. You can see a full list of
channels at siriusxm.com.
While watching the On Demand Multi-Use Display
tune to all of the channels, the dealer demo service is activated.
19.
Check the ACC, LKAS, Lane Departure Warning, Forward Collision Warning, Collision Mitigation Braking
™
System
, and Road Departure Mitigation Indicators
When you first turn the ignition to ON, these indicators should come on for a few seconds and then go off:
•
ACC (Adaptive Cruise Control [with low speed follow]) (Advance)
•
LKAS (Lane Keeping Assist System) (Technology and Advance)
•
Lane Departure Warning (Technology and Advance)
•
Forward Collision Warning (Technology and Advance)
•
Collision Mitigation Braking System
•
Road Departure Mitigation (Technology)
®
Radio Dealer Demo Service (Except in Alaska and Hawaii)
™
(ODMD), tune to several channels within the full lineup. If you can
™
(Advance)
®
Radio dealer demo service. Once you install the
Page 10 of 11
Advertisement
