Adjusting Salt Consumption - Midea UP2-HK Instruction Manual

E. Usually, the salt warning light will be cease to be illuminated within 2-6 days
after the salt container has been filled with salt.
F. Immediately after filling the salt into the salt container, a washing programme
should be started (Suggest choose rapid program). Otherwise filter system, pump
or other important parts of the machine may be damaged by salty water. It is out
of warranty.
NOTE
The salt container must only be refilled when the salt warning light in the
control panel comes on. Depending on how fully the salt dissolves, the salt
warning light may still be on even though the salt container is filled.
If there is no salt warning light in the control panel (For some Models), you
can judge when to load the salt into the softener by the cycles that the
dishwasher had run.
If there are spills of the salt, a soak or a rapid program should be run to
remove the excess salt.

Adjusting Salt Consumption

Please follow the steps below for adjustment in salt consumption.
Step 1: Enter the status of salt adjustment
Close the door, within 60 seconds after power on, press Self- cleaning button
and hold for 5 seconds, the machine will enter setting mode.
Step 2: select a certain level of salt consumption
Press the Self- cleaning button to select the proper set according to your local
environment, the sets will change in the following sequence:
H4->H5->H6->H1->H2->H3.
The H1 setting is recommended based on the water quality in Hong Kong.
Step 3: Exit the status of salt adjustment
Without any operation in five seconds, the machine will exit from set
mode, the machine is into standby status.
12