Advertisement
Available languages
Available languages
Installation
Figure 2B
D
J
I
INVERTER/CHARGER
3-4
Connect Accessory to Network: Connect a standard Ethernet patch cable to
the RJ45 Ethernet port on the Accessory. Note: This port does not support PoE
(Power over Ethernet) applications.
3-5
Connect Accessory to Power: (Refer to Figure 1, Figure 2a or Figure 2b.)
There are two ways to connect the Accessory to power:
• Connect the AC Adapter
B
and plug the other end into an AC power source supported by a UPS
(Figure 1) or Inverter/Charger (Figure 2a).
• Connect one end of the 12V DC Cable
labeled "DC Power"
Charger
J
. This feature is available on select models only.
Note: The Accessory must be plugged into a power source protected by a UPS or
Inverter/Charger in order to maintain communications during a power outage.
3-6
Connect Accessory to Device: (Refer to Figure 1, Figure 2a or Figure 2b.)
Using the standard serial cable provided, connect one end to the Accessory port
labeled "UPS/APS"
Inverter/Charger
201110124-93-3108.indb 6
C
B
A
A
to the Accessory via the port labeled "DC Power"
B
and connect the other end
C
and the other end to the DB9 serial port on your UPS or
D
.
E
F
A
to the Accessory via the port
I
directly to the Inverter/
6
G
H
11/3/2011 11:59:52 AM
Advertisement
