Tripp Lite SNMPWEBSOLO Installation And Quick Start Manual page 11

Features
C1 C2
RESET
201110124-93-3108.indb 11
PS/2 Port: Use this port to connect a Tripp Lite ENVIROSENSE
environmental sensor to provide remote temperature/humidity
monitoring and a dry contact interface to control and monitor
alarm, security and telecom devices. Contact Tripp Lite Customer
Support for ordering information. Note: Do not connect a keyboard
or mouse to this port.
Mini-DIN Serial Port: Use this port to provide a direct terminal
connection to a computer with a terminal emulation program.
A configuration cable (part number 73-1025) is included with the
Accessory. If you need to order a replacement cable, contact
Tripp Lite Customer Support.
Ethernet Port: Use this RJ45 jack to connect the Accessory to the
network with a standard Ethernet patch cable. The Link LED
and Status LED C2 indicate several operating conditions, as shown
in the table below. Does not support PoE (Power Over Ethernet)
applications.
Accessory Operating Conditions
C1
Link LED Color
Off
Flashing Amber
Flashing Green
C2
Status LED Color
Off
Steady Green
Flashing Amber
Reset Button: Press the reset button for 3 seconds to reboot the
Accessory. Rebooting the Accessory will not erase network settings
or interrupt AC power. Note: The recessed button is located just
beneath the Ethernet port. Use a pin, paper clip, or pointed tool to
access the button.
No Network Connection
100 Mbps Network Connection
10 Mbps Network Connection
Accessory Not Initialized
Accessory Initialized and Operational
Error - Accessory Not Initialized
11
C1
11/3/2011 11:59:53 AM