Klutch 49414 Owner's Manual page 15

See Figure K and Figure L
18. Mount the inner Motor Base Cover and Motor Mount Plate.
a. To prepare the Motor (42) for mounting, remove the Motor from the Inner Motor Base Cover
(39) by unthreading the two Hex nuts and Hex bolts holding it in place for shipping.
b. Mount the Inner Motor Base Cover (39) to the Shaft (35), slide Flat Washers onto two Bolts
(24), and insert the Bolts through the Motor Base Cover and the Iron Tube Fixture (15).
Secure with Washers and Lock Nuts.
c. Attach the Motor Mount Plate (40) to the Inner Motor Base Cover (39), insert four Bolts (37)
through the holes in the Fixed plate (38), Cushion (62), Motor Base Cover channels. Thread
Locknuts (55) and washer onto the Bolts, but DO NOT tighten the locknut at this stage.
Note: The Motor Mount Plate must be adjusted up or down to tighten the V Belt (61).
Bolt &Washer
Washer &Locknut
Fig. K
Fig. L
Fixed plate (38)
Locknut (55)
Inner Motor Base
Cover (#39)
Page 15 of 24
Channels
Bolt & Washer
Cushion (62)