Klutch 49414 Owner's Manual page 14

See Figure J
16. Attach Degree Adjusting Wheel (20) to Iron Tube (18) shaft.
a. Insert Coil Spring (22) into the lower hole.
b. While holding the spring in place, slide the wheel over the iron tube.
Note: The Bolt (69) usually have been secured in place, this step may need a little exertion in
order to compress the spring sufficient to be able to slip the wheel onto the Iron Tube. If you
can't compress the coil spring in place, gradually loosen the Bolt (69) then try to slip the wheel
onto the Iron Tube. Tighten this bolt against the Coil Spring.
c. Line up the holes in the bracket on the wheel with the hole drilled in the Iron Tube, then insert
the Bolt (23) with Flat Washer at the bolt head.
Note: You will find it an easier task to line up the holes on one side of bracket only, to begin
with. Enter the bolt, and then use that as a pivot, by pushing the wheel IN to square it up, in
order to line up the holes on the other side. When the holes at the opposite side are aligned,
tap the bolt through GENTLY to avoid damaging the threads.
d. Screw the locknut against the bracket, but not so tight so as to prevent the wheel from
pivoting about the bolt. The wheel must be allowed to pivot about the bolt so that the lugs on
the wheel can be engaged or disengaged from the slots in the Degree Adjusting Plate.
17. Screw the Handle (64) into the Degree Adjusting Wheel (20) hub and tighten.
Lugs
Slots
Degree Adjusting arm (20)
M8*25 bolt
Coil spring
Handle (64)
Page 14 of 24
Coil spring
Degree Adjusting wheel (20)
Fig. J