Klutch 49414 Owner's Manual page 12

See Figure D
12. Carefully place the Drum Upper (4) onto the Connector Seal. Make sure that the holes in both
align. Note: When placing the Drum Upper, align the Mixing Blade mounting holes in the side of
the drums as shown in Figure D. If they are too far away from each other, the Mixing Blades holes
will not match up with the mounting holes on the Drums.
See Figure E
13. Move the Connector Seal from the inside to make sure the holes of Drum Upper, Connector Seal,
and Drum Lower align in a line. Insert Bolt (58) with Washer (57) through the holes and rotate
them by hand. Note: Make sure that six screws are in place, and tighten with a wrench.
Connect Seal (6)
See Figure F and Figure G
14. Mount each Mixer Blade (2) inside the assembled Drum. The V-shaped bend in the Mixer Blade
should point in the direction of the Drum rotation (clockwise). Insert Hex Bolt (1) with Washer (3)
from outside, then Washer (3) and Lock Nut (5). Tighten with a wrench.
Drum Upper (4)
Fig. D
Align the holes
(Figure E)
Fig. F
Page 12 of 24
Mixer Blade
Mount holes
Mixer blade (2)
Bolt (58) &Washer (57)
Fig. G