Assembly Instructions - Klutch 49414 Owner's Manual

See Figure A
1. Place Stand (30) onto Hinge Bracket (34) so that the bolt holes line up.
2. Insert Hex Bolts (26) with Washer (27) through the holes from one side, then Washer (27) and
Lock Nut (23) from the other side, and tighten with a wrench.
3. Insert Support Bracket (25) onto Stand (30) so that the bolt holes line up.
4. Insert Hex Bolts (26) with Washer (27) through holes from one side, then Washer (27) and Lock
Nut (23) from the other side, and tighten with a wrench.

Assembly Instructions

Support bracket (25)
Stand (30)
Hinge bracket (34)
Page 10 of 24
Fig. A
Lock Nut M8 (28)
Washer Φ8 (27)
Bolt M8X70 (26)