Mini CLUBMAN Owner's Manual page 160

CONTROLS
– Malfunction.
– The system is being reset.
Additional information
The status control display additionally
shows the current tire inflation pressures.
The values shown are instantaneous meas-
urements and may vary depending on driv-
ing or weather conditions.
Resetting the system
Via the Central Information Display (CID):
1. "My MINI"
2. "Vehicle status"
3. "Tire Pressure Monitor"
4. Start the engine but do not drive off.
5. Reset tire pressure: "Perform reset".
6. Drive away.
The wheels are displayed in gray and the
following is displayed "Resetting Tire
Pressure Monitor...".
After a travel time of several minutes, the
set tire inflation pressures are accepted as
reference values. The resetting process is
completed automatically while driving.
After successful completion of the reset, the
tires appear in green on the Control Display
and "Tire Pressure Monitor active. See label
for recommended pressures." is displayed.
You may interrupt this trip at any time.
When you continue driving the reset re-
sumes automatically.
Messages
General information
A low tire inflation pressure may cause the
DSC Dynamic Stability Control to be
switched on.
160
Safety
Online Edition for Part no. 01405A541A8 - II/22
Safety information
Warning
A damaged regular tire with low or miss-
ing tire inflation pressure impacts han-
dling, such as steering and braking re-
sponse. Runflat tires can maintain limited
stability. There is a risk of accident. Do not
continue driving if the vehicle is equipped
with normal tires. Follow the information
on runflat tires and continued driving with
these tires.
If a tire inflation pressure check is
required
Message
An icon with a Check Control message ap-
pears on the Control Display.
Icon Possible cause
The system has detected a wheel
change, but no reset was done.
No reset was performed for the
system. The system issues a warn-
ing based on the tire inflation
pressures stored during the last
reset.
Inflation was not carried out ac-
cording to specifications.
The tire inflation pressure has
fallen below the level of the last
reset.
Measure
1. Check the tire pressure and correct as
needed.
2. Reset the system.