Table of Contents
Advertisement
Jun. 2021
Attaching the Rubber Tube
1.
Give attention to the following points when securing the Tube
Escutcheon to the Bottom Case using the screws c (x 2). (Plain view (2),
View 6)
fig.kumitate-tb1.eps
• The tube must be passed through under the wirings connected to the
MIDI Board.
• The battery wirings must be under the Tube.
• An acetate tape must be affixed on the Battery Terminal.
2.
Set the Tube along the arrangement line on the Main Board.
3.
Secure the Mouthpiece Assy to the Bottom Case using the screw V (x 1).
(Plain View (1), View 1)
4.
Connect the Sensor Board to the Main Board with the wiring
(#5100073923).
Arrange the wirings so that they are not on the Main Board.
fig.kumitate-tb2.eps
5.
Secure the Tube on the Main Board with the acetate tape (#40122812).
(4 locations)
fig.kumitate-tb3-e.eps
Near CN19 Next to CN7
Next to CN6
Next to CN8
fig.kumitate-tb4-e.eps
OK
Tube
4
Not OK
Tube
Attaching the Panel-Center Board
When securing the Panel-Center Board to the Top Case, use two types of
screws. Use the silver screw (#40011267) at the location where 6 is printed
near the screw hole on the board.
* If the wrong screw is used, note that the tip of the screw protrudes from the Top
Case.
fig.kumitate-panel.eps
Attaching the Top Case Assy
When attaching the Top Case Assy to the Bottom Case, give attention to
the following points.
1.
Connect the flat cable (1 location) to the Main Board.
2.
Tilt the protrusion (tip) of the Top Case at an angle, insert it into the
mouse piece holder so as not to touch the breath sensor.
fig.kumitate-top1.eps
3.
Adjust the position of the Top Case Assy so as to fit the Bottom Case
completely.
Make sure that the protrusions of the Top Case do not pinch the Tube.
fig.kumitate-top2.eps
4.
Secure the Top Case Assy to the Bottom Case using the screw s (x 1).
(Plain view (2), View 7)
AE-30
Advertisement
Table of Contents
