claber OASIS EVOLUTION 8054 Manual
  1. Manuals
  2. Brands
  3. claber Manuals
  4. Lawn and Garden Equipment
  5. OASIS EVOLUTION 8054
  6. Manual

claber OASIS EVOLUTION 8054 Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
CLABER OASIS EVOLUTION 8054
POSITION:
Oasis Evolution must be installed in closed environments, protected from atmospheric agents and poor
weather conditions. To prevent the water in the internal tank from overheating, position Oasis Evolution
in a shaded and cool area, away from windows or glass partitions and in any case, away from direct
sunlight.
Once the installation position has been selected, lift Oasis Evolution holding it at the bottom with both
hands and place it on a unit or a shelf, at a height of approximately 40 - 45 inches from the ground: the
unit or the shelf must be stable, level and be able to support the weight of Oasis Evolution when full of
water (approximately 60 lbs). Also, make sure that Oasis Evolution is at least 28 - 32 inches from the
edge of the tallest pot.

Advertisement

Table of Contents
loading

Related Manuals for claber OASIS EVOLUTION 8054

Summary of Contents for claber OASIS EVOLUTION 8054

  • Page 1 CLABER OASIS EVOLUTION 8054 POSITION: Oasis Evolution must be installed in closed environments, protected from atmospheric agents and poor weather conditions. To prevent the water in the internal tank from overheating, position Oasis Evolution in a shaded and cool area, away from windows or glass partitions and in any case, away from direct sunlight.

  • Page 2: Fitting The Batteries

    Position the plant pots on the floor in a semicircle near the unit where Oasis Evolution is positioned. Remember to place a pot saucer below the plants to collect any excess water. Plant the plastic stakes provided in the soil: each stake will correspond to a dripper(the maximum number of drippers that can be used with Oasis Evolution is 20 and the minimum is 1.
  • Page 3 Remove the control panel as shown above. The Oasis Evolution needs two new AA alkaline 1.5V batteries that have never been used, with an expiry date exceeding one year. Act on the keys on the sides of the front panel until you hear it engage. If present, remove the dead batteries.
  • Page 4 Lift up the front panel and reposition it. For optimal operation, it is recommended that the batteries are replaced at least once a year. Before using Oasis Evolution, check the battery charge by turning the dial to any program and checking the display.
  • Page 5 Unroll the hose laying it out in a ring. Make sure that it does not create a hazard or obstruct people or animals. Once all the pots have been connected, bring the hose back to the second connector in the front panel of Oasis Evolution (if necessary, cut off the excess hose using scissors).
  • Page 6 Connect a dripper by pressing the hose firmly onto each end: make sure that the dripper outlet is facing downwards. Use the same procedure for all the other stakes, until all the drippers required have been fitted. You have now created the circuit which will distribute the water to the pots, complete with drippers.
  • Page 7 Oasis Evolution has 5 programs (4+OFF), specially designed to allow independent operation for 7, 14, 21 or 28 days automatically, which can be selected using the programming selector switch on the front. The display switches on with the first click of the dial. Always remember to press START to confirm your choice (including for OFF).
  • Page 8 Regardless of the water level in the tank, Oasis Evolution will deliver the same amount of water to your pots each day (see table) throughout the programmed period, thanks to a special internal device which automatically regulates the water pressure. As can be seen in the table, the time and water dispensing change according to the program selected.
  • Page 9 To select the desired program, turn the dial from OFF to the desired position: 7, 14, 21 or 28 days, and press START. Press the START button again, as many times as the number of hours you wish to delay the start time by.

  • Page 10: Turning Off

    The amount of time remaining before the irrigation cycle will start is shown on the screen. Once the cycle has started, the time remaining until the end of the cycle is shown. At the end of the cycle, the time until the next irrigation cycle is shown. TURNING OFF: If Oasis Evolution is not used for a certain period of time, switch it to OFF mode by turning the dial on the front panel and pressing START.
  • Page 11 For your Oasis Evolution to operate correctly, you must expel all the air from inside the circuit. Set up the system and switch on your Oasis Evolution with your preferred program. Disconnect the hose connected to the dripper halfway along the loop circuit, put your finger over one end to seal it, and wait for water to flow from the free end.

  • Page 12: Cleaning The Filter

    Now put a finger over the end of the hose from which water is flowing, and at the same time remove your finger from the other end of the circuit allowing the water to flow. At this point, reconnect the hose to the dripper and restore the loop circuit. CLEANING THE FILTER: The filter must only be removed and refitted when the tank is empty.

  • Page 13: Cleaning And Maintenance

    If necessary, remove the filter and rinse under running water. CLEANING THE DRIPPERS: The drippers can be cleaned and inspected to allow them to be cleaned inside if necessary: to do this, separate the two pieces which make up the dripper and rinse them under running water. CLEANING AND MAINTENANCE:...
  • Page 14 When no longer in use: set the programming selector switch to OFF. Disconnect both ends of the hose from their connectors, blow into the hose to drive all the water out and into a container. Remove the cover and lift Oasis Evolution from the bottom using both hands.

  • Page 15: Periods Of Inactivity

    Then empty into a sink. PERIODS OF INACTIVITY: Check the state of the filter and eliminate any impurities from the water which may have been caught by the mesh. Remove the batteries.
  • Page 16 Use a soft cloth to dry the inside and outside of the tank. Store Oasis Evolution with the cover fitted in a closed environment where the temperature does not fall below 37 °F. Do not disconnect the drippers from the hose: this avoids the risk of pieces being lost, and the distribution circuit will be ready the next time it is needed.

Table of Contents