Disassembling The Thermoblock - LAVAZZA blue LB 400 CLASSY PLUS Maintenance Manual

E

12.9.1. DISASSEMBLING THE THERMOBLOCK

A
B
Warning
Be careful not to tear the pipe. While reassembling, the CLAMP must be
replaced and tightened with the OETIKER PLIERS.
34
Technical support maintenance manual
Figure E: lift the DISPENSING
UNIT upwards and remove all the
connected wiring.
Then remove it from the machine.
Note
The THERMOBLOCK is inserted
in the DISPENSING UNIT.
Figure A: unscrew the fixing
screws of the thermoblock (one on
each side) and extract the compo-
nent.
D
Note
While reassembling, tighten the
screws with a torque of 2 ± 0.1
Nm.
Figure B: remove the high pres-
sure SILICONE PIPE after having
cut the fixing CLAMP.
H
N
Rel. 0.00 / February 2020