Castex QJY-S3 Manual page 14

Scissor Lift
5. Move the plates (42B) outward, and position the rubber saddles (39B) to contact the
vehicle lifting points. (See Figure F and G.)
6. WARNING!
points. Do not use sub-standard shims or other devices in place of approved and
recommended rubber saddles (39B) adapters. Never use the scissor lift without the rubber
saddles in place on each plate (42B) and in contact with the lifting points of the vehicle.
(See Figure F.)
7. Once the rubber saddles (39B) have been positioned under the vehicle lifting points,
operate the power switch to lift the vehicle slightly, and test to make sure the vehicle is
well balanced and the contact between the rubber saddles and vehicle lifting points are
secure. Then, proceed to lift the vehicle to the desired height. (See Figure F.)
8. Note: When the vehicle has been lifted to the desired height, and the safety lock assembly
(1C through 11C) has locked in place, make sure to install proper safety jack stands (not
included), under the vehicle once it is lifted to the desired height, as an additional safety
measure.
9. Once the repair work to the vehicle is completed make sure to remove all tools, safety
jack stands, and materials from under the vehicle and scissor lift. Also, make sure the
work area is clear and it is safe to lower the vehicle.
10. To lower the scissor lift, use the power switch and raise the vehicle slightly to take weight
off the safety lock assembly (1C through 11C). Then, release pressure on the power switch.
(See Figure E.)
11. Stand well away from the scissor lift and vehicle. Then squeeze and hold in the brake
lever (13B) while at the same time pushing in and holding the pressure release valve
handle (3A) to slowly lower the scissor lift all the way down to the floor.(See Figure E.)
Do not lift the vehicle if you cannot establish secure and level lifting
14
QJY-S3