Table of Contents
Advertisement
Hill launch assist (HLA)
PRINCIPLE OF
OPERATION
The Hill Launch Assist (HLA) makes
it easier to pull away when the vehicle
is on a slope without the need to use
the parking brake.
When the HLA is active, the vehicle
will remain stationary on the slope for
two to three seconds after you
release the brake pedal. During this
time, you have time to move your
foot from the brake to the
accelerator pedal and pull away. The
brakes are released automatically
once the clutch is engaged and the
engine has developed sufficient drive
to prevent the vehicle from rolling
down the slope. This is an advantage
when pulling away on a slope e.g.
from a car park ramp, traffic lights or
when reversing uphill into a parking
space.
WARNING
The HLA does not replace the
parking brake. When you leave
the vehicle, always apply the parking
brake and select first or reverse gear.
USING HLA
The HLA can operate in either
automatic or manual mode. If you
select automatic mode, the HLA is
activated automatically when the
vehicle is on a slope and you press
the brake pedal. If you select manual
mode, you must activate the HLA
using the brake pedal.
To set the HLA mode:
E70499
Hill Launch
Off
Auto
Manual
E74629
1. Press the right arrow button on
the steering wheel to enter the
main menu.
2. Highlight Setup with the up and
down buttons and press the right
arrow button.
3. Highlight Hill Launch and press
the right arrow button.
168
Advertisement
Table of Contents
