Table of Contents
Advertisement
16
T u n e T o t I n s t a l l a t i o n a n d C a r e
2.
Lay a 10" digital level, such as the Husky, horizontally on the
top plane of TuneTot. Check the level.
3.
You may rotate the spike tips in place by hand. Lengthen the
appropriate spike or spikes on the lower side until TuneTot is
level. You may rotate the spike tips in place by hand.
4.
Adjust the Adjustable spikes until TuneTot is level side -to-side,
and providing a solid, level mount with no rocking.
5.
Recheck to make sure that TuneTot is still positioned for cor-
rect time domain.
6.
Using the supplied 9/16" wrench, and taking care to avoid mov-
ing TuneTot out of position, tighten the nuts installed on the
Adjustable spike by sliding the wrench in the space beneath
TuneTot. Tighten the nuts such that they are locked and secure
against the bottom of the cabinet. Do not over tighten.
Section 2�5—Removing the Protective Film
Note: To avoid damaging the TuneTot 's painted surface. Please remove any
jewelry such as rings, watches, necklaces, and bracelets during this process.
To protect the finish of TuneTot during final manufacture, shipment, and
setup in your listening room, we have applied a removable layer of protective film
A u t h e n t i c
G u i d e
E x c e l l e n c e ™
S e c t i o n 2 � 6 — C o n n e c t i n g T u n e T o t t o a n A m p l i f i e r
over the finish. We recommend that this film be left in place until the speakers
are in their final location in your listening room. Once you have determined their
final position, remove the film by following this procedure:
1.
Ensure the speaker sur face is room temperature before remov-
ing the protective film.
Note: Removing the protec tive film when the speaker sur face is cold can
damage the paint sur face.
2.
Slowly remove the film from the top down, large sections at a
time, gently pulling the film downward and outward.
Note: Tearing the film aggressively can damage the paint.
3.
Take care in removing the protective film near edges and cor-
ners to prevent paint damage in these areas.
4.
The protective film should not be left on the painted sur face
for extended periods of time nor exposed to heat sources and
direct sunlight.
Section 2�6—Connecting TuneTot to an Amplifier
High quality "five -way " binding post connections are provided to facilitate
connecting TuneTot to your amplifier. Several different types of speaker-cable
hardware are compatible with the post, including spades and banana-style con-
W i l s o n
A u d i o
S p e c i a l t i e s
1 7
Advertisement
Table of Contents
