KBC WESII-KT Series Quick Start Manual

Quick Start Guide
WESII-KT-*
17dBi to 17dBi ptp kit
Introduction
Welcome to KBC Networks' Quick Start Guide for
the WESII point-to-point kit with 17dBi Host &
Client antennas. This document provides some
quick tips on how to get up and running. For
more detailed information, see the Downloads
section below.
Features:
 5GHz operation
 MIMO technology
 Dynamic Frequency Selection
 Transmission Power Control
 Antenna alignment & signal survey tools
 IP66 casing
Downloads
Installation manual
Other features and functions are described in the
unabridged manual:
http://www.kbcnetworks.com/wes-ii-point-to-
point/wireless-products/wesii-point-to-point
Specification Sheets:
http://www.kbcnetworks.com/wes-ii-point-to-
point/wireless-products/wesii-point-to-point
Quick_Start_Guide_WESII-KT_Rev1205
Copyright © KBC Networks Ltd. 2012
WESII Wireless Ethernet System
System Contents
Qty Description
1 WESII Single Point Host/AP RF Module
1 WESII Client RF Module
2 Mid-span compliant power injector module
2 24VDC PSU for each power injector
module included
2 Strain relief kit assembly
2 Wall or pole mount bracket and assembly
kit each including:
1 Bracket body
1 Pole clamp bracket
1 Connecting piece 1
1 Connecting piece 2
1 U bolt
1 50mm, 1.98" long ¼" hex bolt
3 ¼" hex nuts
1 27mm, 1.06" long ¼" hex bolt
3 Flat washers 15mm, 0.59"
3 Locking washers 10mm, 0.39" long
1 U bolt
4 ¼-20 lock washers
Equipment Required for Physical
Deployment
You will need 4 straight-through Ethernet cables:
KBC recommends shielded outdoor rated
Ethernet cables when connecting near power
outlets and when exposed to the elements.
www.kbcnetworks.com