BOLERO AGUAZERO 6600 Instruction Manual page 74

ENGLISH
Filters
Clean the filters and the spray arms at least once a week. If there are food remains or strange
objects in the fine and coarse filters, remove the filters and clean them thoroughly with water.
Fine filter
-
Coarse filter
-
Metallic filter
-
Removing and cleaning the filters
Fig. 22
Turn the filtering set counterclockwise and remove it by lifting it upwards.
1.
Remove the coarse filter (b) from the fine filter (a).
2.
Rinse the filter with plenty of water until it is free from residues.
3.
Reassemble the filters. Place the filtering set again and turn it clockwise.
4.
WARNING: do not wash any filter in the dishwasher.
NOTE:
The washing effectiveness will decrease if the filter is placed incorrectly.
-
The use of clean filters is necessary for the correct operation of the dishwasher.
-
Spray arms
Fig. 23
Make sure the spray arms are not blocked and there are no food remains or strange objects
sticked to them. If there is some blockage, remove the spray arms and clean them under
running water.
Loosen the nut which holds the upper spray arm in its position by turning it clockwise and
1.
then pull from it downwards.
Make sure the nut is perfectly tightened when you assemble the upper spray arm.
2.
Drain pump
Large food residues or strange objects which the filters have collected may block the drain
pump. If this occurs, rinse water will accumulate over the filter.
Warning, risk of cuts! When cleaning the drain pump, be careful not to cut yourself with
any broken glass or sharp instruments.
In this case:
Unplug the device from the electric circuit.
1.
Remove the baskets.
2.
Remove the filters.
3.
Empty the water, use a sponge if necessary.
4.
74