Advertisement
True Wireless Earbuds
Charging Case
Three Pairs of Ear-Tips (S/M/L)
USB-A to C Cable
User Manual
Quick Start Guide
Warranty Card
Model | EP-T32 |
Technology | A2DP, AVRCP, HFP, HSP, SBC, AAC, APTX |
Driver (each channel) | 1 x 12mm / 0.36" speaker driver |
Sensitivity | 95±3dB @1kHz |
Frequency Range | 20Hz – 20kHz |
Impedance | 32Ω±15% |
Microphone Type | MEMS (microphone chip) |
Charging Time | 2 hours |
Battery Life | 9 hours |
Battery Type | Li-polymer (2 x 55mAh) |
Operating Range | 10m / 33ft |
Weight | 7g / 0.25oz (pair) |
Charging Input | DC 5V |
Charging Time | 3 hours |
Battery Type | Li-polymer (600mAh) |
Number of Earbuds Recharges | 4 times (pair) |
Weight | 86g / 3.03oz |
Fully charge the charging case before the first use. To charge, connect the case to a USB charger or charging port with the included USB-A to C cable, or use a wireless charger (5W) to charge the charging case. When the LED Charging indicator on the outside of the case turns off, the case is fully charged. Charging may take around 3 hours, then case can offer fully charge to the earbuds 4 times. The earbuds should be stored in the case when not in use.
Note: Remove the protective film from the earbuds when using for the first time.
Turn On | Open the lid of the charging case or touch and hold on the touch-sensitive panels on both earbuds for 2 seconds when they are turned off |
Turn Off | Return both earbuds to the charging case and close the lid or touch and hold on the touch-sensitive panels on both earbuds for 5 seconds when they are turned on |
Starting with the earbuds in the case:
Note
Some devices don't follow the Qualcomm True Wireless Master–Slave pairing protocol and may display a message that "The connection was not successful." However, this won't affect the use
Once the earbuds are successfully paired with your device, they can be switched on and off as follows:
Starting with the earbuds in the case:
Notes
Once paired, you can wirelessly stream audio on your device via earbuds. Music will automatically get paused when you receive an incoming phone call and will be resumed once the call ends.
Play or pause music | Tap the touch-sensitive panel on either earbud or remove either earbud from the ear |
Skip to previous track | Double tap the the touch-sensitive panel on the left earbud |
Skip to next track | Double tap the the touch-sensitive panel on the right earbud |
Answer or end a call | Double-tap the touch-sensitive panel on either earbud to answer or end a call regarding an incoming call |
Reject an incoming call | Long-press the touch-sensitive panel on either earbud for 2 seconds |
Activate Siri or other voice assistants | Triple-tap the touch-sensitive panel on either earbud |
LED Charging Indicator | Status |
Flashing Red | Charging Case being charged |
Off (after charging) | Charging Case fully charged |
LED Battery Level Indicator | Status |
Three LED Indicators lights for 30 seconds | 60%-100% battery remaining |
Two LED Indicators lights for 30 seconds | 20%-60% battery remaining |
One LED Indicators lights for 30 seconds | ≤20% battery remaining |
The earbuds are on, but not connecting to my device
For the earbuds and your device to establish a connection, you need to put them both in pairing mode. Please follow the instructions in the Pairing section of this manual.
I've connected the earbuds with my smartphone but can't hear any sound
Double-check the volume level on your smartphone and the earbuds. Some smartphones require you to set up the earbuds as an audio output device before the audio can be transmitted. If you're using a music player or other device, please make sure it supports the A2DP profile.
The sound isn't very clear or the caller can't hear my voice clearly
Adjust the volume on your smartphone and the earbuds. Try moving closer to your smartphone to rule out the possibility of interference or wireless range-related issues.
What's the wireless range of the earbuds?
The maximum range is 10m (33ft). However, the actual range depends on environmental factors. For optimal performance, keep your device connected within a range of roughly 4m to 8m and make sure that there are no major obstacles (like reinforced steel walls) between the earbuds and your device.
The earbuds won't turn on
Try charging the earbuds for a while. If the earbuds still won't power on, please contact our support team at the email address given in 'Warranty & Customer Support.'
I put the earbuds back in the charging case, but the earbuds are still connected
The charging case is probably out of power. Try charging it.
For questions, support, or warranty claims, contact us at the address below that corresponds with your region. Please include your Amazon order number and product model number.
Amazon US orders: support.us@aukey.com
Amazon EU orders: support.eu@aukey.com
Amazon CA orders: support.ca@aukey.com
Amazon JP orders: support.jp@aukey.com
*Please note, AUKEY can only provide after sales service for products purchased directly from AUKEY. If you have purchased from a different seller, please contact them directly for service or warranty issues.
Max RF power level:
BT classic (2402–2480MHz): 2.1dBm
RF exposure assessment has been performed to prove that this unit will not generate the harmful EM emission above the reference level as specified in EC Council Recommendation (1999/519/EC).
RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS.
Excessive sound pressure from earphones and headphones can cause hearing loss.
Hereby, Aukey Technology Co., Ltd. declares that the radio equipment type (True Wireless Earbuds, EP-T32) is in compliance with Directive 2014/53/EU.
Notice: This device may be used in each member state of the EU.
This device complies with Industry Canada's licence-exempt RSSs. Operation is subject to the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause undesired operation of the device.
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Advertisement
Need help?
Do you have a question about the EP-T32 and is the answer not in the manual?
Questions and answers