Maytronics Dolphin Nautilus CC Plus Manual

What You'll Find Inside the Box

Filter and cartridges


Robot pool cleaner


Power supply Unit

Description of Main Components

1. Filters
   
   Base frame + fine or ultra-fine cartridge Depend on model
2. Brushes
   There are three types of optional brushes, each designed to provide optimal traction on different pool surfaces. Only one type set is provided with your robot pool cleaner.
   
   PVC Brush
   For concrete, PVC, fiberglass and liner.
   
   Combined Brush
   For rough ceramic surface and mosaic tiles.
   
   Wonder Brush
   For smooth ceramics.
3. Power supply unit
   
   Digital, "Switch-Mode" power supply:
   • Input - 100-250 AC Volts
   • 50-60 Hertz
   • 180 Watt
   • Output - 30 VDC
   • IP 54

Robot pool cleaner Operation

Preparing the Robot Pool Cleaner for Use

Laying out the cable
Unwind minimal required cable to cover the entire pool size, straight the cable along the pool side. Make sure there are no twists or kinks.

Only use the original supplied power supply unit.
The Power supply unit is splash proof – do not immerse it in water.
Unplug the power supply unit before any servicing activity.
Do not plug the power supply unit in before placing the pool cleaner in the water.
Ensure the mains outlet is protected by a ground fault interrupter (GFI) or an earth leakage interrupter (ELI).

Do not enter the swimming pool while the pool cleaner is working.

Into the water

Inserting the robot pool cleaner into the pool.
Place the robot pool cleaner into the pool and release the handle.

Note: When using the combined brushes or Wonder brushes, gently squeeze the Wonder brush material until it is totally wet.

Turning the robot pool cleaner ON

1. Plug the floating cable from the robot pool cleaner into the power supply unit.
2. Plug the electrical cable from the power supply unit into the mains.
   
3. Press the ON/OFF switch
4. The robot pool cleaner will now start to work.
   
   
   Do NOT enter the swimming pool while the pool cleaner is working.

Taking the robot pool cleaner out of the water

Unplug power supply before any servicing activity.

1. If the robot pool cleaner has not finished its cycle, turn off the power supply unit and unplug the mains.
2. Pull the floating cable gently until the robot pool cleaner has risen to the surface, then lift by the handle.
   
   
   Do NOT lift the robot pool cleaner from the water by its cable.

Routine Maintenance

Extracting and cleaning the filter elements

Unplug power supply before any servicing activity.

Reassembling the filter elements
Insert the locating tabs at the bottom of the filter element into their groves on the base frame, then close the "S" clip.


Reinstall the filters according to the diagram DO NOT FORCE THE FILTERS INTO PLACE.


Grooved end fitting


Octagonal end fitting

Recommendation: Rinse all brushes with clean water after each cleaning cycle.

Dismantling and cleaning the impeller

Unplug power supply before any servicing activity.
Dismantle the impeller cover and clean around the impeller housing, then reassemble.

Storage Advice

Coil the cable and store in dry cool area.
Do NOT store the robot pool cleaner exposed to direct sunlight.
Do NOT store the robot pool cleaner exposed to excessive heat.
Do NOT store the robot pool cleaner exposed to frost.

Troubleshooting Guide

Before contacting your robot pool cleaner distributor please read through this guide.
The pool water condition must be within the following parameters:

Videos

Dolphin Nautilus CC Plus Review & Demo Video

Documents / Resources

References

• Dolphin Robotic Swimming Pool Cleaner | Maytronics

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download Maytronics Dolphin Nautilus CC Plus Manual