Jlab Earbuds Go Air POP Manual

BUTTON FUNCTIONS

LEFT

VOLUME DOWN: Single tap
SIRI (iOS) or "OK GOOGLE" (ANDROID): Double tap
TRACK BACK: Press & hold 1+ sec

RIGHT

VOLUME UP: Single tap
PLAY / PAUSE: Double tap
TRACK FORWARD: Press & hold 1+ sec

ANSWER CALL: Single tap
HANGUP: Double tap
REJECT INCOMING CALLS: Press & hold 1+ sec
EQ CHANGE: Triple tap

VOICE PROMPTS

"Hello": Power ON
"Ready to Pair": GO Air Pop is ready to pair to Bluetooth device
"Bluetooth Connected": Earbud is connected to device
"Battery Full": 100-75%
"Battery Medium": 75-25%
"Low Battery": Less than 25% (When power decreases to 10%, "Low Battery" will play one time)
"Goodbye": Power OFF

Tap either the right or left earbud 3 times for different EQ settings (GO Air Pop will cycle 3 EQ settings).

JLab SIGNATURE
JLab C3™ signature sound with amplified bass and vocals

BALANCED
Even sound with no additional enhancements

BASS BOOST
Amplified bass and sub-bass

CHARGING EARBUDS

1. Earbuds will power off when placed in the case and start charging the earbuds.
   
2. Earbuds will auto power on and connect to your device when removed.
   

CHARGING CASE

OR

FITTING

Try all ear tips for best fit and proper seal.

Place the earbud in the ear canal and slightly rotate to adjust for best fit.

QUICK TIPS

• The left or right earbud can be used independently for music and phone calls. Simply choose one and take out of the case to connect.
• Only ONE Bluetooth device can be connected at a time. Turn off Bluetooth on unwanted devices and turn on Bluetooth on chosen device to connect.
• Fully dry off earbuds before putting in the charging case to avoid any damage to the case. The earbuds are sweat/water resistant but the case is not.

Fully dry off the earbuds before putting in the charging case to avoid any damage to the case.

The earbuds are sweat/water resistant but the case is not.

TROUBLESHOOTING

Connection failure or earbuds disconnected from each other (Manual Reset)

1. Keep the earbuds in the charging case and forget "JLab GO Air Pop" from your Bluetooth device settings.
2. Quick tap 7x on one earbud in charging case. Earbud blinks blue 4 times.
3. Quick tap 7x on other earbud in charging case. Earbud blinks blue 4 times.
4. Take both earbuds out of the charging case.
   One earbud will be solid white and other will blink blue/white indicating ready to pair to your device.

Instructional videos at: JLAB.COM/MANUALS

CAUTIONS

• Avoid extreme heat, cold, and humidity.
• Avoid dropping or crushing the earbuds.
• Wax may build up in the earbud tips, lowering the sound quality.
  Carefully remove the wax with a cotton swab or other small tool to improve the sound quality.
• If you experience discomfort or pain, try lowering the volume or discontinuing use temporarily.
• If you experience regular discomfort while using this product, discontinue use and consult your physician.
• We recommend you treat your earbuds as you would a nice pair of sunglasses and keep them in safe location when not in use.

Shop products | Product alerts | Burn-in your headphones

JLab Store + Burn-in Tool