Kanguru Flash Drive User Manual page 12

KanguruWireless LAN
o Peer-to-Peer: all communication is done from client to client
without the use of an access point.
• Channel: displays the channel being used, if any, for this wireless
connection. The communication channel ranges from 1 to 11 (US/FCC,
Canada/RSS) 1 to 13 (Europe/ETSI) or 1 to 14 (Japan/TELEC)
• Setting Tx Rate: displays the transfer rate being used for an active
connection. The value is masked when the state shows the "scanning"
message.
• Power Saving Mode: power saving mode can reduce the power
consumption by temporarily disconnecting wireless connections when the
connection is idle.
• Connection Status Diagrams:
Access Point / WEP disable
Peer-to-Peer / WEP disable
Peer-to-Peer / WEP enable
The receiver can receive excellent signals.
There is no encryption in use.
The receiver can not receive any AP's signal.
There is no encryption in use.
The receiver can receive excellent signals.
There is no encryption in use.
The receiver can not receive any PC's signal.
There is no encryption in use.
The receiver can receive excellent signals.
Encryption is enabled and matched each
other.
The receiver can not receive any PC's signal.
Encryption is enabled and not matched each
other.
- 12 -