Advertisement
1
Turn the mowing head
N
counterclockwise as far as possible
onto the shaft (1)
Block the shaft
N
Tighten the mowing head
N
NOTICE
Remove the tool again used to block the
shaft.
Removing the mowing head.
Block the shaft
N
Rotate the mowing head clockwise
N
Fitting Mowing Head without Screw
Mounting
Keep the instruction leaflet for the
mowing head in a safe place.
FS 111 RX
STIHL FixCut 31-2
Fit the thrust plate (2).
N
Place the mowing head on the
N
thrust plate (2).
WARNING
Collar (see arrows) must engage the
mowing head's mounting hole.
Push the thrust washer (3) (convex
N
side up) over the shaft (1) until it is
seated on the base.
Block the shaft.
N
Use the combination wrench (5) to
N
screw the mounting nut (4) onto the
output shaft and it tighten down
firmly.
WARNING
If the mounting nut has become too
loose, fit a new one.
NOTICE
Remove the tool used to block the shaft.
Removing the Mowing Head
Block the shaft.
N
Use the combination wrench to
N
loosen and unscrew the mounting
nut counterclockwise from the
output shaft.
English
17
Advertisement
