Lincoln Electric VRTEX 360 Service Manual page 160

F-103
REMOVAL AND REPLACEMENT PROCEDURE (continued)
REPLACEMENT PROCEDURE
1. Replace the Table Swing Arm.
2. Carefully guide the Table Swing Arm cable
through the 1¾" access hole in the case back.
3. Insert the plastic grommet into the 1¾" access
hole.
4. Slide the new Table Swing Arm onto the top of
the top of the table mounting post.
5. Replace any previously removed cable ties.
6. Install the strain relief from the Table Swing Arm
cable previously removed from the rear of the
machine.
7. Connect the previously removed cable labeled
"SOURCE" to the polhemus module.
All manuals and user guides at all-guides.com
TROUBLESHOOTING AND REPAIR
TABLE SWING ARM
FIGURE F.48 – CASE BACK (REAR)
VRTEX
8. Perform
Case
Procedure.
9. Perform the
Monitor
Replacement Procedure.
10. See the Retest After Repair.
TM 360
F-103
Cover Replacement
and Pedestal