Teka DH ISLA 120 Instruction Manual page 12

Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 10
Cleaning and maintenance
During cleaning and maintenance work,
make sure the safety instructions set out
on page 10 are complied with.
Cleaning the hood body
• If your kitchen hood is made from stainless
steel, use proprietary cleaners mentioned
in the product instructions.
• Never use metallic scourers, nor abrasive
or corrosive products.
• Dry the kitchen hood using a cloth that
does not produce fibres.
• The use of vapour cleaners is not
recommended.
Cleaning the metal filters
To remove the filters from their fittings, press
lightly on the locks and then pull them off.
The metal filters can be cleaned by soaking
them in hot water with neutral detergent until
the fat dissolves and then rinsing them under
the tap or using special anti-grease products.
They can also be washed in a dishwasher. In
this case, it is advisable to stack them
_________________________________________________________
Proceed with the following checks before calling the Technical Service:
See page 30.
TEKA INDUSTRIAL S.A. reserves the right to make changes and corrections to its products as
it deems necessary, without altering their basic characteristics.
12
vertically to avoid food residues to stick to
them.
Cleaning in a dishwasher may damage the
metallic surface (blackening it), although this
will not affect its fat retention capacity.
Once clean, leave them to dry off and then fit
them onto the kitchen hood.
Fig. 2 (Page 31)
Proceed as follows:
• Remove the metal filters. Loosen the
screws (without unscrewing them) of the
EASYCLEAN panels (K), move the panels
aside carefully and take them off.
• Take away the screws (B) and dismount the
spare part (A).
• Loosen the screws (D) to depress the
cover top (C).
• Change the broken/burnt out lamp (E).
Maximum lamp power is 40W (E-14).
• Mount the supports again (C) and (A).
• Mount the EASYCLEAN panel again (K).
Fit the metal filters.
Problem solving
Sizes and specifications
Changing light bulbs

Advertisement

Table of Contents
loading

Table of Contents