Operation - PRO STORMER BDP40020 Instruction Manual

2. Lower the device into the water at a slight angle to allow any remaining air to
escape.(see fig.9)
3. If you want the device to be positioned on the ground, ensure that the latter is even.
4. Attach the nylon cord to an easily accessible position, so you can pull the device back
out after pumping has been completed.

Operation

Warning!!! Before the device is used for the first time, the air exhausting process
must be completed! Otherwise, the device may not pump water out!
You can adopt two method as below:
1. First put the device into the water, turn the float switch(3) to the M position,
and then switch to the AUTO position after the device is discharged, finally put it
into the deep water.
2. Put the device into the water, turn the float switch(3) to the AUTO position, wait
for about 2 up to 5 minutes, after the device completes the pumping action,
finally put it into the deep water.
Switching the device on
Once you have completely installed the device as described in the Start-up chapter, you can
switch it on.
Automated function
The pump has an intergrated float. Set the switch to the AUTO position( see diagram A
position). once you have plugged the device into the socket, the pump will switch on
automatically when the water exceeds the start-level and switch off when the stop-level has
been obtained. this means that the pump can be left on at all times and will keep the water
in a cellar or boat, for example, at the required level. bear in mind that this pump is not
designed to be used continuously, it must be switched off at regular intervals. despite the
fact that the pump works automatically, regular supervisions is required in order to ascertain
that it has not encountered and functional problems and that it has not been damaged(see
also: overheating safeguard).
14
(fig. 8) (fig.9)