Assembly And Installation - PRO STORMER BDP40020 Instruction Manual

• Hold onto the mains plug while pulling the power cable out of the mains socket.
• Do not use the power cable to drag the device.
Storage
When the device is not being used, observe the following storage conditions:
• dry and protected from frost and heat
• in an upright position where it is protected from dust and direct sunlight
• with a cover to protect it from invasive dust if necessary
• Place no further devices or objects on top of the device to prevent it from being damaged.
If you do not use the device for an extended period of time, it must be cleaned thoroughly after
its last application and before recommissioning. Deposits and residues could lead to start-up
difficulties.

Assembly and installation

Scope of delivery
• 1 x submerged waste water pump
• 1 x reducer for inner diameters 1 inch and 1
• 1 x manual
Unpacking the device
1. Open the cardboard box and take the device out.
2. Completely remove the packaging.
3. Fully unwind the power cable. Make sure that the power cable is not damaged and that you
do not damage it during unwinding.
Start-up
Connecting the pipe or hose line
The device may be operated using either a hose line or a pipe. Ex factory, the device is delivered
with a 1 ½"external thread. Please observe the following information regarding the water
discharge:
• Please note that making use of the reducer (7) might decrease the device performance. The
reducer (7) should be shortened to the used diameter so as not to decrease the device
performance unnecessarily.
• Please note that the device cannot be moved as flexibly when using a solid pipe.
• Please note that the maximum particle size is to be reduced in proportion to the hose or
pipe diameter.
• Please note that the conveying capacity declines with an increasing length of the water
discharge line.
• connect the hose connector to the fitting. The hose connector goes from 1" to 1 1/2 ". If you
are exclusively using a more wide hose, you can remove the remaining piece of the fitting
with a sharp knife or saw. Attach the hose to the appropriate part of the connector with a
hose clamp (or turn it on it). The best results of pumping efficiency are achieved with a 1 1/2
" hose.
11
as well as for 1'' internal threads