Panasonic NV-HS1000 Service Manual page 8

2. BATTERY OPERATION
1) Connect the Battery (Mangan es-Type R6 (AA) 3 pcs./
+4.5V) to P1503 as shown in Fig. S7.
2) After moving the LOADING POST to the unloaded
position, disconnect the battery to stop the motor.
3) Turn the CAPSTAN to clockwise to take up the tape.
4) Reconnect the battery to eject the cassette.
P1503
BATTERY
_1141 5 �1:J
Fig. S7
Fig. S8
If the cassette tape can not be removed by the above 2
methods, remove it by the following method.
1) Remove the Top Panel.
2) Remove the Front Panel Unit.
3) Lift up the Pinch Arm after removing spring.
4) Push the PS Arm and remove the cassette tape from
tape transportation (P1, P2, P3 and PS Posts).
5) Turn the Capstan Motor to take up the tape.
6) Remove 1 screw from the Side Plate (R) Unit to dis­
connect the Rack Gear from the Carriage Connection
Gear.
7) Take out the cassette tape from the Cassette Compart­
ment.
LOADING
MOTOR
P1503
1-1-3. FLAT CARD CABLE INSTLLATION
When installing the Flat Card Cable on the connector, install
the Flat Card Cable with the cable contacts facing the
connector contacts.
CONNECTOR
1-1-4. CHANNEL MEMORY IC INITIALIZATION
When replacing the channel memory IC7503 (XLJ9021 B),
its IC should be initialized.
Note:1) It should be performed before tuning.
2) Do not turn off the power source during initialization
or 1 second after.
3) Meaning of "INITIALIZATION" is to erase the "SKIP
CH" In other words the number of channel position
is the same as displayed channel.
Method:
1) Press the CH UP/DOWN Button so that the channel
indicator indicates "3".
2) Connect a jumper wire between Pin 54 and Pin 35
of IC7501 for more than 1 second.
3) Channel indication changes from "3" to "1 ".
1-4
FLAT CARD CABLE
Fig. S9
•
•
•