Marantz ND8006 Service Manual page 68

(5) READ SUB CODE (playback sound output)
・ Displays the BER (Block Error Rate) for 1 second.
・ Playback position can be changed using the "CURSOR 0 " and "CURSOR 1 " buttons.
・ The unit moves to the inner circumference (IN), middle circumference (MID) and outer circumference
(OUT) positions for playback and performs the error count.
・ The inner (IN), middle (MID) and outer (OUT) circumference positions are calculated from the record-
ing time of the loaded disc to determine the location, and are then moved to through time searches.
・ Err is displayed when no disc is detected.
No Disc display
1-5-3. Pickup movement
・ If button "CURSOR 0 " or "CURSOR 1 " is pressed in the stopped state, the pickup moves in the REV
(inner circumference) or FWD (outer circumference) direction.
・ You can also stop the pickup by pressing the "CURSOR 0 "button. After the inner switch is set to on,
the pickup stops.
・ Release the button to stop the pickup. (The pickup keeps moving while the button is pressed.)
1-5-4. Stop
・Press the "INPUT" or " 2 " button to stop the playback operation and servo.
・After stopping, the auto adjustment values will be read.
1-5-5. All servo on
・ Press the "CURSOR d " button to turn on the all servos and perform auto adjustment. After auto
adjustment completes, the playback operation starts.
(playback sound is output)
1-5-6. Adjustment value display
・ Press "Input" once after executing automatic servo adjustment (see
・ Next, press the "CURSOR d " or "CURSOR f " button to display the adjustment value.
("CURSOR d ": + Direction / "CURSOR f ": - Direction)
NOTE: If automatic adjustment is not completed, a normal value is not displayed.
(1) FOCUS BALANCE
(2) FOCUS GAIN
(3) TRACKING BALANCE
(4) TRACKING GAIN
68
1-5-5. All servo on).
(5) FOCUS OFFSET
(6) TRACKING OFFSET
(7) RFRP