Table of Contents
Advertisement
COUPLING COLLECTOR TO COLLECTOR – CONETITE FITTING
Refer to
installation diagrams on pages
page 23.
1.
Fit a collector union (3) to each collector connection of the first solar
collector (17) to receive the second solar collector and screw in the unions
until they seat firmly against the collector connection, applying medium
pressure with a spanner to tighten.
2.
Place the collector unions (3) into the collector connections on the second
solar collector and screw in the unions until they seat firmly against the
collector connection, applying medium pressure with a spanner to tighten.
END PLUG (COLLECTOR BUNG) ASSEMBLY – CONETITE FITTING
Refer to
installation diagrams
page 23.
1.
Place the collector bung of the end plug (5) assembly into the collector
connection and screw in the gland nut until it seats firmly against the
collector connection, applying medium pressure with a spanner to tighten.
COUPLING COLD AND HOT PIPES TO COLLECTOR – CONETITE FITTING
Refer to
installation diagrams
page 24 and
Detail D
1.
Place the conetite connector of the connector (10) assembly into the solar
cold collector connection and screw in the gland nut until it seats firmly
against the collector connection, applying medium pressure with a spanner
to tighten.
2.
Place the compression nut (11) and olive (12) over the end of the solar
cold pipe. Position the cold pipe into the connector (10) assembly, seat the
olive (12) and tighten the compression nut (11).
3.
Repeat this procedure with the sensor connector (4) assembly to couple
the solar hot pipe to the solar collector (17).
CONNECTION DETAILS
on
pages
on
pages
on page 24.
33
and
34 for position and
32
to
34 for position and
32
to
34 for position and
22
Detail A
on
Detail B
on
Detail C
on
Advertisement
Table of Contents
