Table of Contents
Advertisement
The thread stand is often very simple to assemble but there are a few common issues to pay
attention to.
1.
Assemble the thread stand as shown in figure 5.
2.
Pay close attention to ensure all screws and nuts
are tightened firmly.
3.
Once the thread stand is assembled, it is
important to note that the upper arm of the thread
guide (Fig 5, Item A) is aligned directly above the lower
arm (Fig 5, Item B). failure to align these may cause
tension issues, thread breakages and / or other
machine issues due to poor threading.
4.
To install the thread stand into the table,
separate the washers on the base of the stand so that
there is one washer on the top and one on the bottom
of the table. Then install the lock washer and nut on
the base of the stand and tighten until the thread stand
no longer floats loose and freely.
9
THREAD STAND
Figure 5
TN-1341 INSTRUCTION MANUAL
Advertisement
Table of Contents
