Ryobi RY143011 Quick Reference Manual

RY143011 QUICK REFERENCE GUIDE
WARNING:
This Quick Reference Guide is not a substitute for reading the operator's manual. To reduce the risk of injury or death, user must read and understand
operator's manual before using this product. All page references refer to the operator's manual.
FIRST TIME ASSEMBLY
Install the wheels (see page 9). Connect your garden hose to the pressure washer
1 5
(see page 9).
Unfold the handle assembly (see page 9).
2
Completely uncoil garden hose or remove
completely from reel to prevent kinks.
Turn water faucet on fully.
Make sure there are no leaks.
With no nozzle installed, squeeze the trigger
to relieve air pressure. Hold the trigger until a
steady stream of water appears.
Connect the high pressure hose to the pump (see
6
page 9).
Connect the spray wand to the trigger handle (see
3
page 9).
Connect the high pressure hose to the trigger
4
handle (see page 9).
STARTING THE UNIT
1 Connect the pressure washer to the power supply. Press the reset button on the plug to make sure the unit is
ready for operation (see page 11).
This pressure washer is not recommended for use with an extension cord. If using an extension cord, arrange a
drip loop to avoid the possibility of the tool plug getting wet (see pages 2 and 7).
USE ONLY THIS SIZE EXTENSION CORD WHEN
USING THIS PRODUCT:
Cord Length
NOTE: A.W.G. = American Wire Gauge
2 Press switch ON to start the motor (see page 11).
SWITCH
ON
3
When finished, press switch OFF to stop the motor (see page 11).
SWITCH
OFF
There may be residual water in the
pump due to performance testing.
Pour pressure washer
1
detergent in soap tank (see
page 13).
Wire Size (A.W.G.)
25 ft. 12
50 ft. Not Allowed
Use the chart below to determine the correct nozzle for your job.
Concrete, Brick, Masonry
Siding, Gutters, House
Fencing, Deck, Patio
Lawn Equipment, Boat, RV
Always add Pump Protector to the unit after each use and before storing. This will significantly im-
1
prove pump life. (See page 14.)
Pump protector is available from your local retailer. For further assistance, call customer service at
1-800-525-2579.
To add, follow the instructions provided by the Pump Protector manufacturer.
Make the most of your purchase! Go to www.ryobitools.com
and register your new tool online. For questions about operating
or maintaining your product, please call, 1-800-525-2579.
USING DETERGENT
Install nozzle and rotate Squeeze trigger and wait
2 3
selector to blue or blue approx. 5 seconds for deter-
setting (see page 13). gent (see page 13).
Use of soap nozzle will activate detergent injector at a 20:1 dilution ratio.
WARNING! Never use bleach or solvent-based detergent.
• Will damage your pump
• Will void your warranty
• Will damage plants/shrubs
NOZZLE SELECTION GUIDE
HIGH PRESSURE
(NO SOAP WHEN USING THESE NOZZLES)
Turbo
15º 25º 40º
Nozzle
           
         
         
       
  Recommended Nozzle
Use With Caution for Certain Applications
 
BEFORE STORING THE UNIT
5 S
LOW
PRESSURE
(FOR SOAP OR
GENTLE RINSE)
Short
Long
Range Range
PUMP
PROTECTOR
998000716
10-6-21 (REV:01)