Advertisement
Notes
Mounting, installation
and commissioning
Maintenance
Change of batteries
Reset
4/7
Siemens
Building Technologies
Mount the room temperature controller in a location where the air temperature can be
acquired as accurately as possible without getting adversely affected by direct solar
radiation or other heat or refrigeration sources.
Mounting height is about 1.5 m above the floor.
The unit can be fitted to a recessed conduit box.
When mounting the unit, fix the baseplate first. Then, make the electrical connections
and fit and secure the controller (also refer to the separate mounting instructions).
Mount the controller on a flat wall and in compliance with local regulations.
If there are thermostatic radiator valves in the reference room, set them to their fully
open position.
The controller is maintenance-free.
If the battery symbol
replaced.
To reset, press the reset button on the rear of the unit. All individual settings are then
reset to their default values.
Room temperature controllers
appears, the batteries are almost exhausted and must be
CE1N3069en
14.12.2007
Advertisement
