Agilent Technologies 85050B User's And Service Manual page 25

b. Clean the center and outer conductor mating plane surfaces. Refer to
When cleaning a female connector, avoid snagging the swab on the center conductor contact
fingers by using short strokes.
c. Let the alcohol evaporate, then blow the connector dry with a gentle stream of clean,
low-pressure compressed air or nitrogen. Always completely dry a connector before you
reassemble or use it.
4. Inspect
Inspect the connector to make sure that no particles or residue remain. Refer to
Inspection" on page
85050B
3-3.
Use, Maintenance, and Care of the Devices
Cleaning Connectors
Figure 2-1 on page
"Visual
2-4.
3- 5