Electrostatic Discharge - Agilent Technologies 85050B User's And Service Manual

Use, Maintenance, and Care of the Devices

Electrostatic Discharge

Electrostatic Discharge
Protection against electrostatic discharge (ESD) is essential while connecting, inspecting, or
cleaning connectors attached to a static-sensitive circuit (such as those found in test sets).
Static electricity can build up on your body and can easily damage sensitive internal circuit
elements when discharged. Static discharges too small to be felt can cause permanent damage.
Devices such as calibration components and devices under test (DUT), can also carry an
electrostatic charge. To prevent damage to the test set, components, and devices:
• Always wear a grounded wrist strap having a 1 MΩ resistor in series with it when handling
components and devices or when making connections to the test set.
• Always use a grounded antistatic mat in front of your test equipment.
• Always wear a heel strap when working in an area with a conductive floor. If you are uncertain
about the conductivity of your floor, wear a heel strap.
always ground yourself before you clean, inspect, or make a connection to a static-sensitive
•
device or test port. You can, for example, grasp the grounded outer shell of the test port or cable
connector briefly.
always ground the center conductor of a test cable before making a connection to the analyzer
•
test port or other static-sensitive device. This can be done as follows:
Connect a short (from your calibration kit) to one end of the cable to short the center
1.
conductor to the outer conductor.
While wearing a grounded wrist strap, grasp the outer shell of the cable connector.
2.
Connect the other end of the cable to the test port.
3.
Remove the short from the cable.
4.
Figure 3-1 shows a typical ESD protection setup using a grounded mat and wrist strap. Refer to
Chapter 6 , "Replaceable Parts,"
Figure 3-1 ESD Protection Setup
3- 2
for information on ordering supplies for ESD protection.
85050B