Table of Contents
Advertisement
Available languages
Available languages
ELECTRIC SAFETY
charging the battery
1. insert AD adaptor into the Charging port located on the back of the unit
2. plug the AC adaptor into the closets wall outlet
3. allow 2 hours for the battery to become fully charged
4. disconnect the unit after charging as the unit should be ready for use
5. the LED battery level indicator should be able to tell you the amount of charge that you
have on the battery
6. when all 3 lights (red, yellow and green) are illuminated, the battery is functioning at full
capacity
7. when 2 lights (yellow and red) are illuminated, this indicates that the battery capacity is
begining to diminish.
8. when only 1 light (red) is illuminated, this indicates thta the battery capacity is low and
the unit needs to carged.
PERSONAL SAFETY
a)Stay alert and do not use the tool when under influence of alcohol.
b)Use safety glasses and face or dust mask. Wear protective hearing equipment, helmet and
boots.
c)Avoid unintentional starting. Before connecting to power source or battery, make sure the
switch is at OFF position.
d)Dress properly. Do not wear loose clothing or jewelry. They can be caught with moving parts.
e) Remove adjusting keys and wrenches. Tool or adjusting key you leave attached to a turning
part of the tool may cause injury.
f)
Do not overreach. Proper footing and balance at all times allow better control of the tool in unexpected
situations.
g)
Use approved protective equipment only.
1. The case
2. Speed mode switch
3. Torque converter
4. Removable quick-release cartridge
5. Bit-holder
6. Reverse switch
7. Power button
8. Battery
9. Battery lock
10.
Lamp of illumination
11.
Vents
12.
Charge level indicator
Advertisement
Table of Contents
