Step 2 – Press the Zone button (1, 2, 3 or 4) for the
Zone you want to assign to the Water Leak Sensor.
The LED indicator for that Zone will begin to flash.
Step 3 – Release the Zone button.
Note: Zone 4 is for dedicated alerts only. Sensors in this Zone
will not trigger an alarm or chime.
Step 4 - For the Water Leak Sensor, place the
contacts in a small bowl of water, or use a metal
paperclip and touch both contacts.
Erasing the Sensor from a Zone
Note: If you need to remove the Sensor from a Zone, the
1
2
Zone
system will erase the entire Zone, so any other Sensors will
need to be put back into that particular Zone.
Step 1 - To erase a Zone, press and hold the
Learn button on the Control Center. The unit will
beep once.
Step 2 - While holding the Learn button, press and
hold the Zone button to be erased. After five
seconds the Control Center will sound two beeps
Step 2
Select the Zone number
1 2 3 4
3
4
Input DC 12V
-
Arm
Armed Power
8
Step 1
Press and hold
the Learn button
for three seconds
Step 3
Release the
Zone button
+
Step 4
Mute
Activate the Water
Leak Sensor
Learn
Alert
Chime
Off
Need help?
Do you have a question about the 45133 and is the answer not in the manual?