Control Terminal Descriptions - Delta SVG300A43A-11 Quick Star

3-3 Control terminal description
Position
Wiring precautions:
Place the wires into the wiring hole and tighten the wirings with a flathead screwdriver, note that it is
best to leave 5mm spacing at the wiring end. Note [using wrings without terminal blocks and place
the wires neatly into the wiring hole] only applies to specific positions (terminals B, C in the figure
above).
Terminal Description of Function
Common terminal for digital
E24V
control signals (Source)
Common terminal for digital
COM
control signals (Sink)
MI1 Multi-function input terminal
MI2 Multi-function input terminal
Multi-function output contact 1
RA1
(Relay normally open a)
Multi-function output contact 1
RB1
(Relay normally closed b)
Multi-function output contact 2
RA2
(Relay normally open a)
Multi-function output contact 2
RB2
(Relay normally close b)
Multi-function output contact 1
RC1
common terminal (Relay 1)
Multi-function output contact 2
RC2
common terminal (Relay 2)
Figure 3-1 Control terminal location
Suitable wire size
A 24~10AWG
B
26~16AWG
C
P6RS-485 port*2
Torque
14.3Kg-cm(12.41 lb-in) (1.4N.m)
8Kg-cm(6.94 lb-in) (0.78N.m)
5Kg-cm(4.3 lb-in) (0.49N.m)
Factory setting (NPN mode)
E24V±5% 100mA Factory setting E24V-COM short circuit
Common terminal for multi-function input
None (factory default), RUN/STOP, EF1. RESET*
None (factory default), RUN/STOP, EF1. RESET*
Resistive load
5A(N.O.)/3A(N.C.) 250VAC;
5A(N.O.)/3A(N.C.) 30VDC
Inductive load (COS 0.4)
2.0A(N.O.)/1.2A(N.C.) 250VAC;
2.0A(N.O.)/1.2A(N.C.) 30VDC
Outputs various monitoring signals, such as in operation
(Running), in preparation (PLL OK), error display, warning
display, and standby ready
Factory default: none
3-7
Specifications