Advertisement
Quick Links
Torpedo
This Quick Start Guide summarizes the basic steps required to install and configure the Torpedo DVB-S/S2 or DVB-
T/T2 to IP Gateway Appliance (single chassis, as shown below*) to stream digital broadcasts onto an IP network.
Please refer to the User's Guide or the online help (available from the Web Interface) for detailed information.
* The color of your Torpedo may be different from those pictured above.
Installing the Torpedo
1.
Unpack the box and visually inspect the package contents for any evidence of shipping damage. [See Impor-
tant Notice for list of contents.]
2.
Install the Torpedo as a desktop unit on a flat, well-ventilated surface.
3.
Connect the power cable.
CAUTION
Always use the AC power cord and power supply provided with the unit. Connect the power
supply first to the chassis and then to the AC source.
Make sure the connector is properly inserted and locked to avoid intermittent power problems.
HVS-ID-QS-TORP-220, Issue 02
Q
S
UICK
TART
™
DVB-S/S2 or DVB-T/T2
to IP Gateway Appliance
HVS-ID-QS-TORP-220, Issue 02
G
UIDE
Page 1 of 7
Advertisement
Summary of Contents for Haivision Torpedo
- Page 1 IP Gateway Appliance This Quick Start Guide summarizes the basic steps required to install and configure the Torpedo DVB-S/S2 or DVB- T/T2 to IP Gateway Appliance (single chassis, as shown below*) to stream digital broadcasts onto an IP network.
- Page 2 Torpedo Quick Start Guide Connecting the Torpedo to the Network Connecting the Torpedo to the Network Connect the Torpedo’s Ethernet port to the IP network using an Ethernet UTP cable (Type Cat 5 or higher) (DVB-S/S2 shown in following example). 10/100 Base-T...
- Page 3 Open a Web browser, type the IP Address for the Torpedo into the URL address bar, and press Enter. Log in to the Torpedo Web Interface, using the default username and password. Configuring the LNB and DiSEqC settings (Dish Setup, DVB-S/S2 only) NOTE There is no LNB configuration on DVB-T/T2 systems, so Dish Setup is not required.
- Page 4 To save your changes, click NOTE A service scan is required when the Torpedo is first installed. A service scan updates the list of ser- vices and multiplexes that the unit has stored. It can take several minutes and while underway, no servic- es will be streamed.
- Page 5 Torpedo Quick Start Guide Starting a Service Scan (DVB-T/T2) Starting a Service Scan (DVB-T/T2) Click from the main menu and then click YSTEM ETUP The Scan Setup page opens (as shown in the following example). From here, you can start a service scan and set the parameters used for scanning.
- Page 6 YSTEM ULTIPLEX The Multiplex List (as shown in the following example) displays information on the currently tuned multiplex, as well as the other available multiplexes for this Torpedo. Frequency To view and configure the channels for a multiplex, click the link for the multiplex.
- Page 7 Streaming services are listed on the Status page (as DMINISTRATION shown in the following example). For More Information Contact Haivision Technical Support via our Support Portal on our website at: http://www.haivision.com/support/ Or you may use the phone number or email address listed below: North America: Toll Free: 1.877.224.5445...